Serial Dilution Calculator

Fill in the fields and press Calculate to see the result.

About the Serial Dilution Calculator

Plan a serial dilution: the volume to transfer and the diluent for each tube, and the concentration of every tube for any dilution factor.

It works with molar and mass concentrations, percentages, CFU/mL, cells/mL or copies/µL. Enter the volume each tube should hold before the next transfer.

How it is calculated

Transfer = V ÷ factor · Diluent = V − transfer · Tube n = C₀ ÷ factorⁿ

In a serial dilution each tube is diluted by the same factor from the one before: a tenfold series (1:10) puts 100 µL into 900 µL of diluent for 1 mL tubes, and every tube is ten times weaker than the previous one. The transfer is the tube volume divided by the factor, and the diluent makes up the rest. After n steps the concentration is the starting one divided by the factor to the power n.

Put the diluent in every tube first, then transfer from the stock to tube 1, mix well, change the tip and continue down the series. Because each transfer is taken out of the tube, every tube except the last ends with the tube volume minus the transfer. Serial dilutions are used for plate counts (CFU), standard curves, antibody titers and cell counts.

Example

A twofold series of 8 tubes from 2 mg/mL with 500 µL per tube: transfer 250 µL into 250 µL of diluent each time. The last tube holds 0.0078125 mg/mL, a total dilution of 1:256.

Frequently asked questions

How do I make a 1:10 serial dilution?

Fill each tube with 9 parts of diluent, for example 900 µL, add 1 part (100 µL) from the previous tube and mix. Each tube is then ten times more dilute: 10⁻¹, 10⁻², 10⁻³ and so on.

How do I calculate CFU/mL from a serial dilution?

Count the colonies on a plate with 30 to 300 colonies and divide by the volume plated (in mL) times the dilution of that tube. 150 colonies from 0.1 mL of the 10⁻⁵ tube give 150 ÷ (0.1 × 10⁻⁵) = 1.5 × 10⁸ CFU/mL.

More Lab Calculators